5 Prior to initial operation 5.5 Feeder unit 67081 73259 5.5.4 Checking the cutterbar float springs The cutterbar float springs (1) are pre-set ex works. The cutterbar float springs (1) must be checked and adjusted with the front attachment fitted. 1 Fit the front attachment. Fit the crop dividers. Lower the cutterbar until the skids are about 100 mm above the ground. 3 12 19598 2 13 19599 The distance (Y) between the coupling pin cylinder plate and the nuts should be 5 mm. Adjust the cutterbar float springs if required. - To do this, adjust the cutterbar float springs accordingly at the socket head bolts (2).
Observe the general warnings at the beginning of the Prior to initial operation chapter. 2 Y Danger! Bolts may break when tilting the spring plates. 19600 14 Death or serious injuries! Ensure that the tilted position of the spring plate near the bolt pitch circle diameter may be 1 mm max. Grease bolt threads. Now turn the bolts in or out by 3 revolutions each (5 mm) max., one after the other. 00 0293 210 2 - BA DOMINATOR 150/140/130 - 12/09 97 Adjusting the bolts (2): Increasing the distance Turn bolts in Reducing the distance Turn bolts out