256 Working hydraulics circuit II R working hydraulics circuit I is deactiva- ted ( Y page 244) R working hydraulics circuit II is deactiva- ted ( Y page 253) R the continuous consumer has been switched off ( Y page 252) X Press button K . The indicator lamp in button K goes out. The flow rates are again distributed to cir- cuit I Z and circuit II Z . Hydraulic system Switching front working hydraulics cir- cuit II to standby mode Working hydraulics circuit II, vehicles with positioning pump X Connect the equipment to the working hydraulics (see the manufacturer's sepa- rate operating instructions) ( Y page 230).
General notes Working hydraulics flow rates, see "Technical data" ( Y page 374). X Start the engine. X Make sure that the hydraulic system is switched on ( Y page 230). Activating/deactivating front working hydraulics circuit II X Press button V . The indicator lamp in button V flashes. The Hydraulics input window opens in the on-board computer. Front working hydraul- ics circuit II line Z is selected. Front work- ing hydraulics circuit II is in standby mode. ! Only switch on the hydraulic system when it is connected to an item of attached equipment. There is otherwise a risk of damage to the hydraulic system. Selecting an operating mode X Attached equipment with constant flow rate:
make sure that LS is not in the input window. If necessary, press and hold the u button until a flow rate is shown. or X Equipment with load sensing: press and hold the t button until LS is shown in the input window. Attached equipment with constant flow rate, change the flow rate X Using the u and t buttons, increase or decrease the flow rate.