264 Equipment operation X To deactivate: press the Щ button repeat- edly until the Rotational speed input window appears on the on-board com- puter. "Settings", "Function button" menu window ( Y page 241). X Press the blue button on the control lever. Constant working speed mode is activated. The working speed is set to the setpoint. X Press the u Deactivate button. The working speed can be reset with the gas pedal. X To deactivate: press the blue button on the control lever. Constant working speed mode is deactiva- ted. The working speed can be reset with the gas pedal. Activating/deactivating using the control lever without the blue button X To activate and set:
make sure that engine speed mode is activated ( Y page 262). Power take-offs X Press the F button upward or down- ward. The Rotational speed input window appears in the on-board computer. The engine speed is increased or decreased incrementally by approximately 20 rpm up to the setpoint. General notes Working mode Power take-offs are intended for operating auxiliary equipment. The engine and power take-offs must be operated at a certain engine speed/working speed, depending on conditions of use. Depending on the vehicle equipment, the working speed can be set with the accelerator or constant working speed can be activated.
On vehicles with speed limitation, the preset engine speed cannot be exceeded when the PTO is engaged. For vehicles with additional equipment fitted, read the equipment manufacturer's operat- ing instructions before starting operation with the PTO. X To set the working speed using the set- point: press the F button upwards or downwards until the setpoint has been reached. X Release the F button and press upward or downward again. X To change and save the setpoint: press the F button upward or downward until the desired working speed has been reached. X Press the t SET button on the steering wheel. The setpoint is saved. Types of power take-off There are two types of power take-off:
trans- mission-driven power take-off and engine- driven power take-off. X To deactivate: press the F button upward or downward. X Press the u Deactivate button on the steering wheel. The working speed can be reset with the accelerator pedal. Activating/deactivating using the control lever and with the blue button X To activate: make sure that engine speed mode is activated ( Y page 262). X To select the working speed function for the blue button on the control lever, see the