Tipper platform 281 X Remove screws ? from lifting cylinder B on the underside of the tipper platform. X Remove left and right locking pins H from pins F . X Replace screws ? with two M12 x 50 mm set screws. X Using the handle, turn left and right pins F upwards and remove them from rear ball sockets G . X Remove screws A . X Raise the tipper platform slightly with the crane and fold in safety prop C . X Using the crane, carefully lift the tipper platform horizontally and remove it. X Turn the key to position 2 in the ignition lock.
X Simultaneously lower the tipper platform with the control lever/switch ( Y page 277) and with the crane, until the tipper platform is completely resting on the ball sockets. X Open the rear platform dropside ( Y page 274). Working mode X Unscrew magnet I from the tipper plat- form. X Attach the D lifting gear to rear lashing points E on the platform floor. X Close the rear platform dropside ( Y page 274). X Attach magnet I to switch J , e.g. with adhesive tape. The Y indicator lamp in the status area of the on-board computer remains off when the tipper platform has been removed. X Make sure that lifting cylinder B has been fully retracted. X Lash lifting cylinder B to the frame.
This helps to prevent damage to the fit- tings. Z