Tipper platform 283 X Make sure that the quick-change platform is lowered completely. The Y indicator lamp in the status area of the on-board computer must be not be lit and the ball sockets of the quick-change platform must rest completely on the balls. X Switch off the engine. X Open the rear platform dropside ( Y page 274). X Attach lifting gear C at the front and back to the D lashing points on the platform floor. Working mode X Close the rear platform dropside ( Y page 274). X Remove left and right locking pins = from pins : . X Carefully raise the quick-change platform horizontally with the lifting gear. X Using the handle, turn left and right pins :
upwards and remove them from rear ball sockets ; . X Unscrew magnet E from the quick-change platform. X Pull out locking pin B on catch lever C . X Push catch lever C inwards in the direction of the arrow until it engages in retainer spring ? . The lifting cylinder is mechanically decou- pled from the quick-change platform. The quick-change platform only rests on the 4 balls of ball sockets ; . Z