Where will I find...? 313 Window cleaner/scraper with tele- scopic pole Assembling/disassembling the pump lever (2-part) G WARNING If you do not assemble the pump lever as described, the handle can slip out of the guide while pumping. There is a risk of injury. Make sure that the locking pin of the pump lever is engaged in the hole intended for the purpose. Use the pump lever to operate: R the jack R the wheel wrench R the cab tilt pump Breakdown assistance X Open stowage compartment = ( Y page 312) and remove the window cleaner/scraper. X Press telescopic pole : downwards (arrow) and pull it out to the rear. : Recess (jack) ; Jacking point (wheel wrench/cab tilt pump) = Locking pin ?
Recess (for operating the winch and jack) A Hole for the locking pin B Retaining sleeve X Screw the window cleaner/scraper onto telescopic pole : . X Loosen the screw connection of telescopic pole : . X Extend and tighten the moving part of tele- scopic pole : . X Clean the window, follow instructions ( Y page 286). X Remove the pump lever from the tool bag located in the stowage space in the rear left of the cab ( Y page 312). X Loosen the screw connection of telescopic pole : . X To assemble the pump lever: insert pump lever locking pin = into recess ? . X Retract and tighten the moving part of tele- scopic pole : . X Unscrew the window cleaner/scraper from telescopic pole :
and place it in stowage compartment = . X Turn the pump lever. Locking pin = engages in hole A . X To disassemble the pump lever: press locking pin = and pull apart the pump lever. X Slide telescopic pole : into the front of guide ; and press upwards at the back until it engages in retaining clamp ? . Z