Cylinder Head and Valves CTM100 (06APR04) 02-020-27 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=99 Clean, Inspect, and Measure Valves 1. Hold each valve firmly against a soft brass or copper wire wheel on a bench grinder. IMPORTANT: Any carbon left on the stem will affect alignment in valve refacer. DO NOT use –UN–21MAY98 a wire wheel on plated portion of valve stem. Polish the valve stem with steel wool or crocus cloth to remove any scratch marks left by the wire brush. RG8322 2. Make sure all carbon is removed from valve head, Measuring Valve Stem face, and unplated portion of stem. 3. Inspect valve face, stem, tip, and retainer lock groove. 4.
Measure valve stem OD Record measurements and compare with valve guide ID. (See MEASURE VALVE GUIDE ID, later in this group.) –UN–05DEC97 Specification Intake and Exhaust Valve Stems—OD................................................... 8.999 ± 0.013 mm (0.3543 ± RG4234 0.0005 in.) 5. Using a valve inspection center, determine if valves are Measuring Valve Face Runout out of round, bent, or warped. Specification Intake and Exhaust Valve Face1—Maximum Runout....................................... 0.038 mm (0.0015 in.) 6. Measure valve head OD. Specification Intake and Exhaust Valve Head— OD.........................................................
46.35—46.61 mm (1.825—1.835 in.) 1Maximum runout measured at 44 mm (1.73 in.) diameter. RG,RG34710,78 –19–13AUG99–1/1 02 020 27