Cylinder Head and Valves CTM100 (06APR04) 02-020-43 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=115 NOTE: Carefully inspect threads on 8 mm cap screw prior to use to avoid damaging injector hold-down clamp threads in cylinder head. Replace cap screw as needed. 4. Install JDG981-3 Guide Sleeve Holding Bar (A) as shown. Install 220213 (8 mm) cap screw (B) finger –UN–05DEC97 tight. 5. Install 220089 (16 mm) cap screw (C) from combustion face side of head using a phosphate washer from RG8155 cylinder head mounting cap screw finger tight. Installing Guide Support Bar 6. Install JDE131-2 Driver Nut (D) finger tight. 7. Tighten cap screws and nut in following order to specification given:
• 16 mm Cap Screw (C) to 115 N•m (85 lb-ft) • 8 mm Cap Screw (B) to 47 N•m (35 lb-ft) –UN–05DEC97 • Guide Sleeve Nut (D) to 150 N•m (110 lb-ft) A—JDG981-3 Guide Sleeve Holding Bar B—220213 (8 mm) Cap Screw RG8157 C—220089 (16 mm) Cap Screw D—JDE131-2 Driver Nut Guide Support Bar Cap Screw –UN–05DEC97 RG8156 Guide Sleeve Arbor Nut Continued on next page RG,RG34710,92 –19–28NOV00–5/6 02 020 43