CTM100 (06APR04) 02-030-3 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=143 Cylinder Block, Liners, Pistons, and Rods Install Front Plate IMPORTANT: All gasket contact surfaces MUST BE clean, dry, and free of sealant and oil. Earlier service front plate gaskets used sealant. New gaskets DO NOT require sealant. 1. Install new gasket onto dowels in cylinder block. 2. Install front plate onto front face of block. 3. Install five countersunk screws and tighten to specifications, following sequence in illustration. Specification Front Plate-to-Cylinder Block Cap Screws—Torque.............................................................. 50 N•m (37 lb-ft) –UN–20MAY98 4.
Install engine oil pump assembly. (See INSTALL ENGINE OIL PUMP in Group 060.) 5. Install idler gear and camshaft gear. Adjust gear RG8814 backlash. (See CHECK AND ADJUST CAMSHAFT-TO-CRANKSHAFT TIMING in Group Front Plate Torque Sequence 050.) 6. Install auxiliary drive gear (if equipped). (See REMOVE AND INSTALL AUXILIARY DRIVE IDLER GEAR AND BEARING in CTM67, OEM Engine Accessories, Group 54.) 7. Install timing gear cover. (See INSTALL TIMING GEAR COVER in Group 040.) 8. Install engine oil pan. (See INSTALL ENGINE OIL PAN in Group 060.) 9. Install crankshaft vibration damper and pulley. (See INSTALL CRANKSHAFT VIBRATION DAMPER AND FRONT OIL SEAL in Group 040.) 10.
Remove JDG971 Timing Pins and install rocker arm cover. (See REMOVE AND INSTALL ROCKER ARM COVER in Group 020.) 11. Install crankshaft timing pin plug and tighten to specifications. Continued on next page RG,RG34710,106 –19–01NOV00–3/4 02 030 3