Delphi — Remove Cylinder Liners Using JDG1145 Cylinder Liner Service Set

Cylinder Block, Liners, Pistons, and Rods Remove Cylinder Liners Using JDG1145 Cylinder Liner Service Set NOTE: JDG1145 Liner Puller (A) shown with liner removed to illustrate proper assembly of tool. 02 030 14 1. Remove cap screws and washers securing liners to cylinder block. RG10341 –UN–10SEP99 2. Number cylinder liners and mark fronts to ensure correct assembly. NOTE: Each cylinder liner must be reinstalled in same cylinder bore from which removed. Always keep matched pistons and liners together. JDG1145 Installation 3. Use JDG1145 Cylinder Liner Service Set (A) with a 2.27 kg (5.0 lb) slide hammer (B) to remove cylinder liner. IMPORTANT:

When using JDG1145 as shown (A) to remove liners, make sure puller is properly assembled before attempting to remove liners. Step in bottom plate of puller assembly should fit in ID of liner. RG10339 –UN–09SEP99 DO NOT over-tighten liner puller to remove liners. Doing so could easily break liners. Remove Cylinder Liner A—JDG1145 B—Slide Hammer C—Liner Puller 4. Install liner puller (C) in liner. 5. Attach a 2.27 kg (5.0 lb) slide hammer (B) to liner puller as shown and remove liner. Continued on next page DPSG,OUO1004,1026 –19–09SEP99–1/2 CTM100 (06APR04) 02-030-14 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=154