CTM100 (06APR04) 02-030-27 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=167 Cylinder Block, Liners, Pistons, and Rods IMPORTANT: ALWAYS measure liners at room temperature. 4. Measure liner bore parallel to piston pin at top end of ring travel (A). 3 –UN–07JAN0 5. Measure bore in same position at bottom end of ring travel (B). RG10049 6. Measure bore at right angle to piston pin at top end of ring travel (C). Measuring Liner ID 7. Measure bore in same position at bottom end of ring travel (D). 8. Compare measurements A, B, C, and D to determine if liner is tapered or out-of-round. 9. Compare liner ID with matched piston OD.
Specification Cylinder Liner—ID................................................. 126.990—127.010 mm (4.9996—5.0004 in.) Max. Out of Round................................................. 0.020 mm (0.0008 in.) Max. Wear or Taper (Ring Travel Area)....................................................................... 0.030 mm (0.0012 in.) Piston-to-Liner Clearance (New Part 6105)—Clearance.................................................. 0.092—0.138 mm (0.0036—0.0054 in.) Max. Acceptable Wear........................................... 0.152 mm (0.0060 in.) Piston-to-Liner Clearance (New Part 6125)—Clearance..................................................
0.060—0.100 mm (0.0024—0.0039 in.) Max. Acceptable Wear........................................... 0.152 mm (0.0060 in.) Replace piston and liners (as a set) if they exceed wear specifications given. RG,RG34710,119 –19–13AUG99–2/2 02 030 27