Measure Piston Protrusion 1. Press down on top of piston to remove oil clearances. contact. Specification Piston (Early Engines)— Protrusion Above Block Deck 0.229—0.787 mm (0.009—0.031 in.) ................................. 2. Use JDG451 Gauge along with D17526CI (English scale) or D17527CI (Metric scale) Dial Indicator, or use KJD10123 Gauge to measure piston protrusion. Place gauge on top of cylinder block so dial indicator can be set to (0.000) with top of block. Piston (RE505901) (Later 12.5 L Engines)—Protrusion Above Block Deck 0.079—0.637 mm (0.003—0.025 in.) .............................................................. 3. Position gauge across top of piston.
While pressing gauge downward, rotate crankshaft until piston is at 6. Repeat procedure on remaining pistons and record measurements. If protrusion does not meet specification, check dimensions of piston, connecting rod, cylinder block, crankshaft, and bearings to determine the cause. 4. Measure and record piston height at several positions around top OD of piston. 5. Piston protrusion must be within the following specification to prevent piston-to-exhaust valve RG,RG34710,136 –19–01NOV00–1/1 CTM100 (06APR04) 02-030-53 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=193 Cylinder Block, Liners, Pistons, and Rods Check Engine Rotation for Excessive Tightness 1.
Rotate crankshaft several revolutions to be sure engine rotates without excessive tightness. 2. Check liners for deep scratches caused by an improperly installed or broken piston ring. 3. Check side clearance of rods; must have slight side-to-side movement. RG,RG34710,135 –19–30SEP97–1/1 02 030 53