Crankshaft, Main Bearings, and Flywheel Inspect Crankshaft Vibration Damper Refer to your machine operator’s manual for recommended vibration damper inspection frequency. 02 040 1. Remove V-belt (shown removed). 2 IMPORTANT: The vibration damper assembly is not repairable and should be replaced every 5 years or 4500 hours, whichever occurs first. RG8536 –UN–20MAY98 ALWAYS replace vibration damper whenever crankshaft is replaced and at major engine overhaul. Also replace damper when a short block, complete block, or remanufactured basic engine is installed. Checking Damper Rotation 2. Carefully inspect vibration damper for torn or split rubber protruding from front and back of assembly.
RG8537 –UN–10DEC97 3. Grasp vibration damper with both hands and attempt to turn it in both directions. If rotation is felt, damper is defective and should be replaced. 4. Check vibration damper radial runout by positioning a dial indicator so probe (A) contacts damper OD. Measuring Damper Radial Runout A—Probe 5. With engine at operating temperature, rotate crankshaft using JDG820 Flywheel Turning Tool. 6. Note dial indicator reading. Replace vibration damper if radial runout exceeds specifications. Specification Vibration Damper—Maximum Radial Runout 0.76 mm (0.030 in.) .............................................................
RG,RG34710,149 –19–23OCT00–1/1 CTM100 (06APR04) 02-040-2 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=198