Delphi — Remove Rear Crankshaft Oil Seal and Housing Assembly

Crankshaft, Main Bearings, and Flywheel 4. Remove all cap screws securing rear seal housing to cylinder block except top cap screw and two bottom cap screws (A) as shown. 02 040 NOTE: Position split in collet halves at 12:00 o’clock position (C). 14 5. Install JDG1020 Rear Seal and Housing Remover (B) using knife-edge jaws with larger ID. Install puller jaws between seal carrier and seal housing. RG8344 –UN–09DEC97 6. Secure assembly by tightening band clamp securely. Removing Rear Seal Carrier NOTE: Always lubricate forcing screw with multi-purpose grease prior to using. A—Cap Screw B—JDG1020 Rear Seal and Housing Remover C—12:00 O’clock Position 7.

Tighten forcing screw until rear seal and remover is free from seal housing. Wear sleeve portion of seal assembly should remain on crankshaft flange. 8. Remove three remaining cap screws securing seal housing to block and remove housing with gasket. RG,RG34710,161 –19–13AUG99–3/4 9. If necessary, push wear sleeve portion of seal assembly (A) away from block to allow collet halves to be installed behind wear sleeve. 10. Install JDG1020 Remover (B) behind wear sleeve using smaller ID knife-edge jaws. Tighten band clamp securely. RG8295 –UN–06DEC97 11. Lubricate threads and tighten forcing screw until wear sleeve is removed from crankshaft flange. 12.

Inspect crankshaft flange for burrs and nicks. 13. Clean all oil and sealant from crankshaft flange using Brake Kleen or ignition cleaner. Polish burrs with fine emery cloth. Prying Rear Wear Sleeve A—Seal Assembly B—JDG1020 Remover RG8345 –UN–09DEC97 CTM100 (06APR04) 02-040-14 P OWER T ECH 10.5 L & 12.5 L Diesel Engines Removing Rear Wear Sleeve Using JDG1020 RG,RG34710,161 –19–13AUG99–4/4 040604 PN=210