Delphi — Remove Crankshaft Main Bearings

Crankshaft, Main Bearings, and Flywheel Remove Crankshaft Main Bearings NOTE: A drop in oil pressure, engine knock, or excessive crankshaft end play are indications of main bearing and main thrust bearing washer failures. 02 040 16 IMPORTANT: Before removing main bearing caps, check for proper torque on all main bearings. Also, check each bearing cap to make sure they are numbered for reassembly on the same numbered main bearing web. Keep matched bearing inserts with their respective main bearing caps for comparison with corresponding crankshaft journal to check surface wear. RG8127 –UN–20NOV97 JDG996 Main Bearing Cap Puller NOTE:

When removing main bearings and caps for crankshaft removal, leave No. 1 and 7 main bearing caps installed until all connecting rod caps have been removed. RG8126 –UN–20NOV97 1. Remove engine oil pan and pick-up tube. (See REMOVE ENGINE OIL PAN in Group 060.) 2. Remove front timing gear cover. (See REMOVE TIMING GEAR COVER in this group.) Installing JDG996 Puller 3. Remove rear oil seal and housing. (See REMOVE REAR CRANKSHAFT OIL SEAL AND HOUSING ASSEMBLY in this group.) A—JDG996 Puller B—Tip C—Cap Screws 4. Remove main bearing cap screws. 5. Install JDG996 Puller (A) so that tip (B) of blind hole puller legs are below bearing cap half. 6.

Tighten hex of actuator pin securely while holding collet portion of puller leg with second wrench. 7. Tighten both cap screws (C) on cross block finger tight. Continued on next page RG,RG34710,162 –19–13AUG99–1/2 CTM100 (06APR04) 02-040-16 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=212