Delphi — Install Crankshaft Vibration Damper and Front Oil Seal

CTM100 (06APR04) 02-040-39 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=235 Crankshaft, Main Bearings, and Flywheel Install Crankshaft Vibration Damper and Front Oil Seal IMPORTANT: The vibration damper assembly is not repairable and should be replaced every 5 years or 4500 hours, whichever –UN–09DEC97 occurs first. ALWAYS replace vibration damper whenever crankshaft is replaced and at RG8422 major engine overhaul. Also replace damper when a short block, complete block, or reman basic engine is JDG974-2 Forcing Screw Installed on Damper installed. Front crankshaft oil seal (A) must be installed onto vibration damper before installing damper onto engine.

Install Front Seal onto Vibration Damper –UN–09DEC97 1. Apply LOCTITE 680 (TY15969) Retaining Compound around OD of crankshaft flange. Position front oil seal assembly on flange with rubber seal ring facing up as shown. RG8423 NOTE: Lubricate threads of forcing screw with Front Seal Positioned on Damper multi-purpose grease. A—Front Crankshaft Oil Seal 2. Lay vibration damper on table (front face down) with B—JDG974-2 Seal Installer Forcing Screw JDG974-2 Seal Installer Forcing Screw (B) extending C—JDG974-3 Guide Plate through damper ID. 3. Hold forcing screw against front face of damper and position JDG974-3 Guide Plate (C) in ID of damper as shown.

LOCTITE is a registered trademark of Loctite Corp. Continued on next page RG,RG34710,180 –19–13AUG99–1/4 02 040 39