Delphi — Remove and Install Camshaft

CTM100 (06APR04) 02-050-13 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=253 Camshaft and Timing Gear Train Install Engine Camshaft IMPORTANT: Later 12.5 L engines (30000— ) have a redesigned camshaft. This camshaft must NOT be installed in earlier engines ( —29999) or the ECU’s will be –UN–30JUL99 overstroked, resulting in severe engine damage. Additionally, DO NOT install early model camshafts in 12.5 L engines (30000— ). Consult parts catalog for RG10245 correct camshaft part numbers. 1. If removed, install fuel supply pump drive pin in end of Camshaft with Pilot and Holder camshaft.

(See REPLACE FUEL SUPPLY PUMP A—JDG969A Camshaft Holder DRIVE PIN later in this group.) B—Camshaft C—JDG972 Camshaft Pilot NOTE: Engine repair stand must be level during camshaft installation. Traverse hoist during installation so that camshaft bearings do not bind in bushing. 2. Attach JDG969A Camshaft Holder (A) to front face of camshaft (B). Attach JDG972 Camshaft Pilot (C) to rear face of camshaft. Securely tighten all mounting hardware. 3. Coat camshaft lobes and bearings with TY6333 or TY6347 High Temperature Grease. 4. Generously lubricate camshaft bushings with clean engine oil. 5. Support camshaft with overhead hoist and carefully guide camshaft into bushing bores.

Traverse hoist (if possible) as camshaft is installed and keep engine repair stand level to ease installation. Continued on next page RG,RG34710,191 –19–25OCT00–8/14 02 050 13