Camshaft and Timing Gear Train Replace Fuel Supply Pump Drive Pin 1. Remove camshaft. (See REMOVE AND INSTALL CAMSHAFT earlier in this group.) 02 050 2. Remove fuel supply pump drive pin (B) using Snap-On CG503 Dowel Pin Puller Set (A) or equivalent tool. 18 RG10344 –UN–09SEP99 3. Press new drive pin into end of camshaft until it bottoms out. Pin should protrude 15.45—17.45 mm (0.608—0.687 in.) from end of camshaft. 4. Install camshaft. (See REMOVE AND INSTALL CAMSHAFT earlier in this group.) Fuel Supply Pump Drive Pin A—Dowel Pin Puller B—Fuel Supply Pump Drive Pin DPSG,OUO1004,1021 –19–08SEP99–1/1 Visually Inspect Camshaft and Roller Followers 1. Clean camshaft in solvent.
Dry with compressed air. IMPORTANT: Very light score marks may be found on eccentric lobes, but are acceptable if valve lift is within specification. Pitting and galling dictates replacement. RG8385B –UN–09DEC97 2. Inspect all camshaft eccentric lobes and bushing journals (D) for wear or damage. Inspecting Camshaft Lobes 3. Inspect all corresponding rocker arm roller followers for uneven wear or damage. Replace individual roller followers as necessary. A—Intake Lobe B—Exhaust Lobe C—Unit Injector Lobe D—Bushing Journal RG8388 –UN–21MAY98 Inspecting Roller Followers RG,RG34710,192 –19–30SEP97–1/1 CTM100 (06APR04) 02-050-18 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=258