CTM100 (06APR04) 02-080-1 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=301 Group 080 Air Intake and Exhaust System Extending Turbocharger Life Turbochargers are designed to last the life of the The easiest way to damage a turbocharger is through engine, but because they operate at such high speeds improper start-up and shutdown procedures. Always (100,000 rpm or more), a moment’s carelessness can idle the engine for at least 30 seconds (no load) after cause them to fail in seconds. start-up and before shutdown. Warming the engine up before applying a load allows oil pressure to build up The major causes of turbocharger failures are and lines to fill with oil. attributed to:
Idling the engine before shutdown allows the engine • Lack of lube oil (quick starts and hot shutdowns) and turbocharger to cool. “Hot” shutdowns can cause • Oil contamination the turbocharger to fail because, after high-speed • Ingestion of foreign objects operation, the turbocharger will continue to rotate long • Restricted oil drainage after the engine has been shut off and oil pressure has • Low oil level dropped to zero. This will cause heat to build up and • Operation on excessive side slopes possible bearing damage. It can also cause carbon • Abnormally high exhaust temperatures and varnish deposits to form.
Lack of Lube Oil Oil Contamination Oil not only lubricates the turbocharger’s spinning shaft A second cause of turbocharger failures is and bearings, it also carries away heat. When oil flow contaminated oil. It can be caused by a worn or stops or is reduced, heat is immediately transferred damaged oil filter or not changing the lube oil at from the hot turbine wheel to the bearings, which are recommended intervals. Expecting the oil filter to also heating up because of the increased friction due remove dirt, sand, metal chips, etc., from the oil before to the lack of oil.
This combination causes the they reach the engine or turbocharger can be a costly turbocharger shaft temperature to increase rapidly. mistake because contaminated oil may completely bypass the engine oil filter if the oil filter or oil cooler is If oil flow does not increase and the process continues, clogged, if the filter element is improperly installed, or bearings will fail. Once the bearings fail (which can if the oil is thick during cold weather. happen in just seconds), seals, shaft, turbine and compressor wheels can also be damaged. Four good ways of avoiding oil contamination are:
The principal causes of turbocharger bearing • Always inspect the engine thoroughly during major lubrication problems are low oil pressure, a bent, overhaul. Look especially for any sludge or debris plugged or undersized oil lube supply line, plugged or left in lube oil galleries. restricted oil galleries in the turbocharger, or improper • Change lube oil at recommended intervals. Analysis machine start-up and shutdown procedures. of oil samples at filter change periods can help identify potentially harmful contaminants in the oil. Oil levels and pressure should always be closely • Clean the area around the oil fill cap before adding monitored and all worn hoses and lines should be oil.
replaced. The turbocharger oil supply line should be • Use a clean container when adding oil. checked frequently to make sure it is not kinked or bent, and it should always be replaced with a line of equal size, length and strength. Continued on next page RG,RG34710,1256 –19–23AUG02–1/2 02 080 1