CTM100 (06APR04) 04-150-17 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=365 Observable Diagnostics and Tests Check for Head Gasket Failures –UN–19MAY98 RG8429 Head Gasket A—Combustion Seals B—Gasket Body C—Front of Engine (Flanges) Head gasket failures generally fall into three • White smoke, excessive raw fuel, or moisture in categories: exhaust system. • Rough, irregular exhaust sound, or misfiring. • Combustion seal failures • Air bubbles, gas trapped in radiator/overflow tank. • Coolant seal failures • Loss of coolant from overflow. • Oil seal failures • Excessive cooling system pressure. • Coolant overheating. Combustion seal failures occur when combustion • Low coolant flow.
gases escape between cylinder head and head gasket • Loss of cab heating (air lock) combustion flange, or between combustion flange and cylinder liner. Leaking combustion gases may vent to 2. Shut engine down. Recheck crankcase, radiator, an adjacent cylinder, to a coolant or oil passage, or and overflow tank for any significant differences in externally. fluid levels, viscosity, or appearance. Coolant or oil seal failures occur when oil or coolant 3. Compare your observations from above steps with escapes between cylinder head and gasket body, or the diagnostic charts on the following pages. If between cylinder block and gasket body.
The oil or diagnostic evaluations provide conclusive evidence coolant may leak to an adjacent coolant or oil of combustion gas, coolant, or oil leakage from passage, or externally. Since oil and coolant passages head gasket joint, the cylinder head must be are primarily on right hand (camshaft) side of the removed for inspection and repair of gasket joint engine, fluid leaks are most likely to occur in that area. components. Follow these diagnostic procedures when a head COMBUSTION SEAL LEAKAGE gasket joint failure occurs, or is suspected. Symptoms: 1. Start and warm up engine if it can be safely operated. Examine all potential leakage areas again • Exhaust from head gasket crevice.
as outlined previously. Using appropriate test and • Air bubbles in radiator/overflow tank. measurement equipment, check the following: • Coolant discharge from overflow tube. Continued on next page DPSG,RG40854,281 –19–27NOV00–1/2 04 150 17