Delphi — Check for Intake Air Leaks

CTM100 (06APR04) 04-150-21 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=369 Observable Diagnostics and Tests Check for Intake Air Leaks Loose connections or cracks in the suction side of the air intake pipe can allow debris to be ingested into the engine causing rapid wear in the cylinders. Additionally, on turbocharged engines, compressor damage may occur –UN–23FEB89 and cause an imbalance resulting in bearing failure. Air leaking form loose connections or cracks on the pressure side of the turbocharger can cause excessive smoke and low power. T5906AP NOTE: The following test procedure requires that the air intake be sealed off to pressurize the system.

Air Filter Using a plastic bag to seal the intake air filter is used as an example. CAUTION: Do not start engine during this test procedure. Plastic bag (or whatever material/object is used to seal intake) can be –UN–14DEC99 sucked into the engine. 1. Remove air cleaner cover and main filter element. 2. Put a plastic bag over secondary filter element and RG10664 install main element cover. 3. Remove plug from manifold and using a suitable adapter, connect a regulated air source. Intake Plug 4. Pressurize air intake system to the following A—Intake Plug specification. Specification Intake Manifold—Test Pressure............. 13.8—20.8 kPa (0.13—0.21 bar) (2—3 psi) 5.

Spray soap and water solution over all connections from the air cleaner to the turbocharger or air inlet to check for leaks. Repair all leaks. 6. Remove plastic bag from filter element and reinstall element and cover. DPSG,RG40854,286 –19–07NOV00–1/1 04 150 21