Delphi — Disassemble and Inspect Rocker Arms and Shaft Assembly

Cylinder Head and Valves CTM100 (06APR04) 02-020-21 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=93 Disassemble and Inspect Rocker Arms and Shaft Assembly 1. Remove rocker arms from shaft and identify for installation in same position as removed. –UN–21MAY98 2. Inspect rocker arm shaft for scoring and excess wear at rocker arm contact points. Roll on a flat surface and check for bends or distortion. RG8395 3. Check rocker arm adjusting screws and lock nuts for thread damage. Measure Rocker Arm Shaft 4. Check valve bridges and push tubes for contact wear. 5. Clean all parts with clean solvent. Dry with compressed air. 6. Measure rocker arm shaft OD and rocker arm bushing ID.

Compare measurements with specifications below. –UN–21MAY98 7. Inspect rocker arm roller for uneven wear. Measure roller OD and compare with specifications below. RG8392 Specification Rocker Arm Bushing—ID........................... 38.064 ± 0.013 mm (1.4986 ± 0.0005 in.) Measure Rocker Arm Bushing Rocker Arm Shaft—OD.............................. 38.000 ± 0.013 mm (1.4961 ± 0.0005 in.) Rocker Arm Shaft-to-Bushing— Oil Clearance................................................ 0.064 ± 0.026 mm (0.0025 ± 0.0010 in.) Rocker Arm Shaft Intake and Exhaust Roller—OD..................................................

39.995—40.045 mm (1.5746—1.5766 in.) Rocker Arm Shaft Unit Injector –UN–21MAY98 Roller—OD................................................................ 37.995—38.045 mm (1.4959—1.4978 in.) Replace parts as necessary. RG8390 Measure Rocker Arm Roller RG,RG34710,71 –19–30SEP97–1/1 02 020 21