24. SERVICE PROCEDURE 24.4.2 CHECK OIL LEVEL IN DIFFERENTIAL CASE, ADD OIL WARNING The oil is at high temperature immediately after the machine has been operated. Wait for the oil to cool down before starting the operation. 1. Remove plug G and check that the oil level is near the bottom of the plug hole. 2. If the oil level is low, add engine oil until the oil overflows from the plug hole. For details of the oil to use, see “20. USE OF FUEL, COOLANT, AND LUBRICANTS ACCORDING TO AMBIENT TEMPERATURE”. AE134100 24.4.3 CHECK OIL LEVEL IN FINAL DRIVE CASE, ADD OIL WARNING The oil is at high temperature immediately after the machine has been operated.
Wait for the oil to cool down before starting the operation. 1. Stop the machine so that casting line 1 is horizontal and drain plug P is immediately at the bottom. 2. Remove plug G and check that the oil level is near the bottom of the plug hole. 3. If the oil level is low, add engine oil until the oil overflows from the plug hole. AE134110 For details of the oil to use, see “20. USE OF FUEL, COOLANT, AND LUBRICANTS ACCORDING TO AMBIENT TEMPERATURE”. 3-51