26. HANDLING PAYLOAD METER 10. Install the payload meter to its original position on the panel. After replacing the battery, do as follows. 1) Turn the starting switch to the ON position. 2) Press the memory data clear switch twice to delete the data from memory. (The first time, it will flash; the second time, it will light up and then display the load.) 3) Carry out calibration. 4) After carrying out calibration, operate the dump lever once FLOAT LOWER FLOAT with the dump body empty. Replace the battery within 48 hours. The life of the battery is approx. 2 years.
OPERATION AFTER REPLACING CONTROLLER After replacing the controller, always carry out calibration, and operate the dump lever FLOAT LOWER FLOAT with the dump body empty. IF ERROR MESSAGE PAPE FLASHES (PAPER JAM) NOTICE Never touch the printer head (white). If the printer head is removed, it is impossible to install it again. Always be extremely careful not to let any dust or metal particles inside the controller. If the paper jams, PAPE is displayed on the payload meter load display, so move the machine to a safe place and clear the paper jam as follows. 1. Turn the starting switch key to the OFF position. 2.
Remove the screws (M6 x 4) holding the payload meter, then pull the payload meter out to the front. 5-12