12. OPERATION 9. CHECK REAR VIEW MIRROR, UNDER VIEW MIRROR Check for any damage to the mirrors, and if any damage is found, replace the mirror. Clean all dirt from the surface of the mirror and adjust the angle so that the view to the rear and below the machine can be seen from the operator’s seat. 10. CHECK SEAT BELT AND CLAMPS Check that there is no abnormality in the seat belt or clamps. If any damage is found, replace with new parts. Check for any loose bolts of the clamps mounting the equipment to the machine. Tighten any loose bolts.
When the belt has been used for a long time, if any external damage or fraying of the belt can be seen, or if the clamps are broken or deformed, replace the seat belt. 11. INSPECTION OF TIRES WARNING If worn or damaged tires are used, they may burst and cause serious injury or death. To ensure safety, do not use the following tires. Wear: A tire having tread groove less than 15% of the new tire. A tire worn extremely unevenly or having stepped-type wear. Damage: A tire having a flow which has reached the cords or a crack in the rubber part. A tire, the cords of which are broken or dragged. A tire, the surface of which is pealed (separated). A tire, the bead of which is damaged.
A tubeless tire which is leaking or which has not been repaired. A tire which is aged, deformed or damaged abnormally and which does not seem usable. 12. INSPECTION OF RIMS WARNING Check the rims (wheels) and rings for deformation, corrosion and cracks. In particular, check the side rings, lock rings and rim flanges thoroughly. 2-48