TM2361 (24JUN08) 9015-15-10 450DLC Excavator Operation and Tests 062608 PN=454 Sub-System Diagnostics NOTE: For monitor controller (A4) switches and monitor controller uses the CAN for communication indicators identification, see Monitor. with the engine control module (ECM), main controller (Operator’s Manual.) (MCF), and information controller (ICF). For explanation of the monitor controller NOTE: For additional information on the controller functions, see Monitor Functions. (Operator’s area network (CAN), see Controller Area Manual.) Network Theory of Operation. (Group 9015-15.) Switched power from fuse (F19) is available at terminal A16 on monitor controller (A4).
Hour Meter—The monitor controller displays hours of operation using information received from the ICF The monitor controller receives signals from the through the CAN. For additional information on the following components: ICF, see Information Controller (ICF) Theory of Operation. (Group 9015-15.) • Engine Control Module (A1) • Main Controller (A3) Engine Coolant Temperature Gauge—Engine • Information Controller (A5) coolant temperature sensor (B4) sends a varying • Air Filter Restriction Switch (B16) signal to the monitor controller (terminal C8).
The • Fuel Level Sensor (B18) varying signal represents the varying resistance of the • Engine Coolant Temperature Switch (B19) coolant temperature sensor corresponding to the • Alternator (G3) changing engine coolant temperature. Low resistance 9015 15 10 • Engine Speed Dial (R15) of the sensor causes a high temperature reading on • Key Switch (S1) the engine coolant temperature gauge. • Auto-Idle Switch (S8) • Windshield Wiper and Washer Switch (S9) Specification • Work Light Switch (S10) Engine Coolant Temperature Sensor (B4)—Resistance.....................
7.6 kilo-ohms @ 25°C (77°F) 3.65—4.35 kilo-ohms @ 40°C The monitor controller processes the information from (104°F) these components, then activates the appropriate 2.484—2.916 kilo-ohms @ gauges, indicators, and audible alarms as necessary. 50°C (122°F) 0.98 kilo-ohms @ 80°C (176°F) 0.60 kilo-ohms @ 95°C (203°F) For additional information on the monitor controller 0.45 kilo-ohms @ 105°C display functions: (221°F) 0.30 kilo-ohms @ 120°C • See Monitor Data Items. (Group 9015-20.) (248°F) • See Monitor Data Items Using the Monitor Display.
(Group 9015-20.) Fuel Gauge—Fuel level sensor (B18) sends a varying • See Reading Diagnostic Trouble Codes with Monitor signal to the monitor controller (terminal C2). The Display. (Group 9015-20.) varying signal represents the varying resistance of the fuel level sensor corresponding to the changing fuel The monitor controller is connected to the controller level. Low resistance of the sensor causes a high area network (CAN) at terminals B6 and B7. The reading on the fuel gauge. Continued on next page CS33148,00008E9 –19–21APR06–3/6