John Deere 450DLC — JDLink™ Connection Procedure

TM2361 (24JUN08) 9015-20-8 450DLC Excavator Operation and Tests 062608 PN=498 References JDLink Connection Procedure Connect to Machine Information Gateway (MIG) Controller 1. Locate JDLink MMS direct connector (1). For MIG controller location, see JDLink System Harnesses (W50, W51, W52, W53 and W54) Component Location. (Group 9015-15.) NOTE: AT335476 JDLink MMS Direct Cable is included in the AT347680 JDLink MMS Direct Kit. 2. Connect one end of AT335476 JDLink MMS Direct –UN–30JUL07 Cable to the JDLink MMS direct connector (1), and connect the other end to an ethernet port on the computer.

TX1027263A For more information on connecting to the MIG, see Connect PC Laptop to MIG Controller. (CTM10006.) 9015 20 8 Connect to the GlobalTRACS Terminal (GTT) 1—JDLinkMMS Direct Connector Controller 2—GT config Tool Adapter Connector 1. Locate GT config tool adapter connector (3). For GTT controller location, see JDLink System Harnesses (W50, W51, W52, W53 and W54) Component Location. (Group 9015-15.) NOTE: CV90-J1006 GlobalTRACS Config Tool Cable is included in the 65-J1115-11 PC based JDLink Tool Kit. 2. Connect one end of CV90-J1006 GlobalTRACS Config Tool Cable to the GT config tool adapter connector (2), and connect the other end to a COM port on the computer.

JDLink is a trademark of Deere & Company GlobalTRACS is a registered trademark of Qualcomm Incorporated Continued on next page AA95137,0000C45 –19–31AUG07–1/2