John Deere 450DLC — Machine Information Center (MIC) Application

Machine Information Center (MIC) Application Machine Information Center (MIC) Application is a program that allow dealers and technicians to view and analyze data downloaded from the machine. The Information Controller (ICF) records various data points and stores them for download at a later time. After the data has been downloaded to the Personal Digital Assistant (PDA) it can be transferred to a computer to be analyzed. LD30992,0000224 –19–25APR06–1/1 TM2361 (24JUN08) 9015-20-66 450DLC Excavator Operation and Tests 062608 PN=556 References NOTE: Pump learning procedure takes approximately 40 seconds to complete.

Learning Status Cause Corrective Action Low Eng Speed Actual engine speed less than 500 rpm Check for diagnostic trouble codes Abnormal CAN Communication Increase engine speed to 1600 rpm or more Gate Lock Awaked Pilot shutoff lever moved from LOCKED Move pilot shutoff lever to LOCKED position position Signal Over Range Pump regulator pressure sensor or harness Check for diagnostic trouble codes malfunction Pump control solenoid valve or harness malfunction Save Failed Main controller malfunction Repeat procedure three more times.

If main controller continues to fail saving data, replace controller Learnable Normal — LD30992,00004C8 –19–08JUN06–4/4 9015 20 66 Learning Status Cause Corrective Action Low Eng Speed Actual engine speed less than 500 rpm Abnormal CAN Communication Check for diagnostic trouble codes Increase engine speed to 1600 rpm or more Gate Lock Awaked Pilot shutoff lever moved from LOCKED position Move pilot shutoff lever to LOCKED position Signal Over Range Pump regulator pressure sensor or harness malfunction Pump control solenoid valve or harness malfunction Check for diagnostic trouble codes Save Failed Main controller malfunction Repeat procedure three more times.

If main controller continues to fail saving data, replace controller Learnable Normal —