John Deere 450DLC — Component Checks

References TM2361 (24JUN08) 9015-20-105 450DLC Excavator Operation and Tests 062608 PN=595 CAN Bus Terminator Check Turn key switch (S1) OFF. Disconnect harness from CAN bus terminator. See Engine Interface Harness (W6) Component Location. (Group 9015-10.) T140697B –UN–29MAR01 Measure resistance across terminator pins. LOOK: Does the multimeter read 105—135 ohms? YES: CAN bus terminator is OK. NO: CAN bus terminator has failed. Replace the CAN bus terminator. – – –1/1 9015 20 ,105 Pilot Shutoff Switch Harness Check Disconnect harness from cab. Remove diode from harness.

With the positive lead on the center terminal of the diode, there should be continuity when you probe the two outer terminals with the negative lead. Switch the leads and put the negative lead on the center terminal, there should not be continuity when you probe the two outer terminals with the positive lead. Is there continuity one way and not the other? YES: Diode is good, reinstall the diode into the harness. Continue checkout. NO: Replace the diode. 1—Blue Wire 2—Red Wire With the positive lead on the red wire (2), and the negative lead on the blue wire (1), check for continuity with the pilot shutoff switch handle in the forward position.

Bring the handle back to the rearward position, and check for continuity. TX1005243A –UN–28MAR06 Pilot Shutoff Switch Is there continuity with the handle in the forward position Connector and not in the rearward position? YES: Harness is good. NO: Replace the pilot shutoff switch harness. – – –1/1