References Disconnecting Spring Wire Clip Connectors 1. Remove wire clip from connector. Grasp connector; move connector halves from side-to-side as they’re being pulled apart. Do not pull on wiring leads. 2. To reconnect, install wire clip on connector half, push connector halves together until wire retainer “clicks” over tabs. T8197AO –UN–14MAR94 LD30992,000023C –19–31MAR06–1/1 TM2361 (24JUN08) 9015-20-118 450DLC Excavator Operation and Tests 062608 PN=608 Replace DEUTSCH Connectors 1. Select correct size extractor tool for size of wire to be removed: • JDG361 Extractor Tool for 12 to 14 gauge wire. –UN–23AUG88 • JDG362 Extractor Tool for 16 to 18 gauge wire.
• JDG363 Extractor Tool for 20 gauge wire. 2. Start correct size extractor tool over wire at handle (A). TS0124 3. Slide extractor tool rearward along wire until tool tip snaps onto wire. IMPORTANT: Do NOT twist tool when inserting in connector. 4. Slide extractor tool along wire into connector body until it is positioned over terminal contact. –UN–23AUG88 5. Pull wire out of connector body, using extractor tool. TS120 DEUTSCH is a trademark of the Deutsch Co. Continued on next page LD30992,000023D –19–31MAR06–1/2 9015 20 ,118