John Deere 450DLC — Pilot Control Valve Operation

Theory of Operation Moving the control lever to actuate a function pushes the plunger and spring guide (3) against the balance spring (4), which moves the spool (7) down. During the initial movement (14), there is a deadband area (13) where the flow of return oil (16) through the holes (8) to port T is blocked before pilot oil can flow from port P through the spool to the work port and out to the control valve pilot caps (10). Pilot oil pressure also flows through the orifice (6) to the top of the spool to dampen the upward movement of the spool.

Pilot oil pressure increases until it is equal to the pressure of the balance spring pushing the spool up until the oil flow through the holes is blocked in the deadband area. With the oil flow blocked, the control valve spool is held stationary until the control lever is again actuated. When the control lever is actuated to full stroke, the plunger contacts the spool, pushing it down until the plunger contacts a shoulder in the housing. Oil pressure to the control valve pilot caps is now approximately equal to pilot system pressure. When the control lever is returned to neutral, the spool is pulled up by the return spring (5), pushing the plunger up.

The return spring holds the control lever in the center position. With the spool up, the passage to the control valve pilot cap is open to port T and pilot oil from port P is blocked. LD30992,0000252 –19–31MAR06–2/2 9025 05 11 TM2361 (24JUN08) 9025-05-11 450DLC Excavator Operation and Tests 062608 PN=649