TM2361 (24JUN08) 9025-05-77 450DLC Excavator Operation and Tests 062608 PN=715 Theory of Operation Boom Regenerative Valve Circuit Operation 300 168 301 126 173 180 –UN–20APR06 182 184 TX1006647 185 TX1006647 Boom Regenerative Valve Circuit Schematic 126—Boom 2 Spool 180—Supply Oil 184—Return Oil 300—Orifice 168—Boom Cylinder (2 used) 182—Pilot Oil 185—Regenerative Oil 301—Orifice 173—Regenerative Valve The boom regenerative valve (173) is located inside When regenerative return oil (185) pressure is more the boom 2 spool (126). The boom regenerative valve than pump 2 supply oil (180) pressure, the boom improves boom control and prevents boom cylinder regenerative valve is open.
Regenerative return oil is cavitation during boom down operation. combined with pump 2 supply oil and both are supplied to the boom cylinders rod end. Under the following operating conditions, low delivery pressure from pump 2 and pilot oil pressure to the pilot When pump 2 supply oil pressure is more than cap for boom down, the weight of boom, arm, and regenerative return oil pressure, the boom regenerative bucket causes the boom to lower faster than the pump valve is closed. Pump 1 supply oil only flows to the can supply oil to the boom cylinder rod end. boom cylinders rod end. Regenerative return oil passes through an orifice (301) and on to the oil tank.
Boom down pilot oil shifts the boom 2 spool to the lower position. Oil can then flow from the head end of the boom cylinders to the boom 2 spool. At the boom 2 spool, oil flows to the boom regenerative valve (173). Continued on next page MM61211,0001532 –19–24APR06–1/2 9025 05 77