John Deere 450DLC — Load Drifts Down When Control Valve Is In Neutral Position Diagnostic Procedure

TM2361 (24JUN08) 9025-15-25 450DLC Excavator Operation and Tests 062608 PN=775 Diagnostic Information 3 Boom Circuit Leakage Check TX1006310 –UN–12APR06 Leakage Test Position Position bucket and arm as shown with bucket cylinder fully retracted. 1. Relieve hydraulic pressure from boom circuit. 2. Remove rod end hoses from both boom cylinders. 3. Drain oil from hoses and cap hose ends with high pressure plugs. 4. Leave cylinder rod end ports open and place container under them to catch any excess oil. 5. Start engine and slowly retract arm cylinder so bucket is approximately 300 mm (12 in.) off ground Does oil leak out of rod end of boom cylinder? YES: Repair boom cylinder piston seals. NO:

If boom lowers and no oil leaks out of rod end ports, the control valve is leaking. Inspect and repair control valve spool. Look for broken spring or loose spool end. – – –1/1 Load Drifts Down When Control Valve Is In Neutral Position Diagnostic Procedure – – –1/1 9025 15 25