John Deere 450DLC — Swing Function Does Not Operate Diagnostic Procedure

Upperstructure Drift With Swing Valve In Neutral Diagnostic Procedure –1/1 TM2361 (24JUN08) 9025-15-36 450DLC Excavator Operation and Tests 062608 PN=786 Diagnostic Information 2 Swing Pressure Sensor Check Operate swing with control lever partially moved and note speed. Move swing control lever full travel and note swing speed. Does swing speed slow when control lever is fully activated? YES: Replace swing pressure sensor. NO: Swing horsepower reducing control is malfunctioning. See Main Controller (MCF) Diagnostics Using Dr. ZX. (Group 9015-20.) – – –1/1 1 Swing Park Brake Check See Swing Motor Park Brake Release Circuit Operation.

(Group 9025-05.) See Swing Motor and Park Brake Disassemble. (Group 4360.) Inspect park brake. Is park brake OK? YES: Diagnostic procedure complete. NO: Repair or replace park brake. See Swing Motor and Park Brake Disassemble. (Group 4360.) – – –1/1 9025 15 36 Swing Function Does Not Operate Diagnostic Procedure – – –1/1 1 Actuating Pilot Pressure Check Key on, use monitor service menu to display Swing / Attachment Control Pilot Pressure. See Monitor Service Menu Operation. (Group 9015-16.) NOTE: Spool actuating pressure can be checked for each function by installing a tee and gauge in pilot line and then actuating that function. Perform Control Valve Spool Actuating Pilot Pressure Test.

(Group 9025-25.) Run engine at fast idle and operate problem function. Observe pressure when function held over relief. Is pilot pressure above 3.70 MPa? YES: Go to Park Brake Release Pressure Check. (Group 9025-15.) NO: If pressure is low, adjust or replace valve. Perform Pilot Pressure Regulating Valve Test and Adjustment. (Group 9025-25.) – – –1/1