John Deere 450DLC — Test and Adjustment

TM2361 (24JUN08) 9025-25-40 450DLC Excavator Operation and Tests 062608 PN=900 Tests NOTE: When a pressure reading is fluctuating, increase 95 engine speed slightly. 100 5. Actuate the function over relief for circuit relief valve 111 being check. Record the pressure reading. 85 6. Adjust pressure setting of circuit relief valves to specification as needed. Specification Boom, Arm, and Bucket Circuit Relief Valves—Pressure................................................... 35.3—36.3 MPa 35 300—36 300 kPa 353—363 bar 5120—5260 psi –UN–03MAR06 Auxiliary Circuit Relief Valve (Top Work Port)—Pressure......................................................

35.3—36.3 MPa 35 300—36 300 kPa 353—363 bar 101 84 5120—5260 psi 83 TX1004119 Auxiliary Circuit Relief Valve 96 (Bottom Work Port)—Pressure......................................... 27.9—28.9 MPa 27 900—28 900 kPa Circuit Relief Valves For Right Control Valve (4-spool) 279—289 bar 4045—4190 psi 129 128 138 122 7. Loosen nut using a 19 mm combination wrench. Turn adjusting screw using a 6 mm hex key wrench.

83—Right Control Valve (4-spool) 84—Left Control Valve (5-spool) 85—Main Relief and Power Digging Valve 95—Bucket Dump Circuit Relief and Anticavitation Valve 96—Bucket Curl Circuit Relief and Anticavitation Valve 100—Boom Down Circuit Relief and Anticavitation Valve 101—Boom Up Circuit Relief and Anticavitation Valve 111—Arm Regenerative Valve—Switch Valve 122—Arm Out Circuit Relief and Anticavitation Valve –UN–06MAR06 123—Arm In Circuit Relief and Anticavitation Valve 128—Boom Mode Relief Valve 129—Boom Mode Relief Control Valve 84 138—Auxiliary Circuit Relief and Anticavitation Valve TX1004211 139—Auxiliary Circuit Relief and Anticavitation Valve 83 101 139 123 96 Circuit Relief Valves For Left Control Valve (5-spool) Continued on next page LD30992,0000281 –19–15MAY08–4/5 9025 25 40