145 HYDROSTATIC PUMP LINKAGE BEGINS WITH S/N CMWRT95MK90000264 REF NO. PART NUMBER QTY DESCRIPTION REMARKS NOT SHOWN: FOOTNOTES: 1. TO ATTACH BRACKET (REF #5) USE TWO INSIDE BOLTS LOCATED IN THE REAR OF THE FRONT PUMP ON THE SAME SIDE AS THE TRUNNION SHAFT. 2. APPLY LOCTITE BEFORE ASSEMBLY. 3. UNITS PRIOR TO S/N CMWRT95MK90000264 USE SENSOR 217-269 (1X), BRACKET 315-646 (1X), AND BOLTS 107-268 (2X). NOTE:
06 ID0152909 1 315-735 1 REAR SUPPORT (AUX DRIVE PUMP) 2 110-318 2 BALL JOINT (#10-32, FM) 3 106-678 6 LOCKNUT (1/4-NF) 4 194-196 1 CONTROL CABLE 5 315-484 1 CAM PLATE SEE FOOTNOTE 1 6 105-106 1 BOLT (1/4-NC X 2") 7 106-386 1 FLG LOCKNUT (M8-1.25) 8 315-483 1 PUMP TRUNNION LEVER 9 105-810 2 BOLT (#10-24 X 7/8", SOC) 10 106-205 2 WASHER (.191") 11 331-166 1 BOLT-ON BACK-UP (.306") 12 110-697 1 BOLT-ON CLAMP (.360") 13 107-092 3 WASHER (.254") 14 106-528 4 SCREW (M6-1.00 X 20MM, SOC) SEE FOOTNOTE 2 15 179-301 1 BRONZE BUSHING (.375) 16 116-142 2 SHOCK MOUNT 17 125-491 1 CAM YOKE ROLLER BEARING 18 117-614 4 FRICTION WASHER (.781") 19 105-699 2 BOLT (1/4-NF X 1 1/4") SEE FOOTNOTE 2 20 181-636 1 BUSHING 21 106-989 1 FLG LK SCREW (M8-1.25 X 35MM) 22 179-302 1 SLEEVE (.250) 23 313-954 1 CABLE CONNECTOR 24 215-1175 1 PROXIMITY SWITCH SEE FOOTNOTE 3; BEGINS W/ S/N:
CMWRT95MK90000264 25 105-069 2 WASHER (.406") 26 105-047 2 LOCKNUT (3/8-NC) 27 105-811 2 LOCKNUT (#10-24) 28 105-162 2 BOLT (3/8-NC X 2-1/4") 29 315-536 1 INNER CONTROL ARM 30 300-6250 1 PROXIMITY SWITCH MOUNT SEE FOOTNOTE 3; BEGINS W/ S/N: CMWRT95MK90000264 31 107-414 2 SCREW (M4-0.70 X 30MM,BUT SOC) SEE FOOTNOTE 3; BEGINS W/ S/N: CMWRT95MK90000264 32 106-574 2 CLIP NUT (M6-1.00) 33 105-680 2 NUT (M4, W/LK WSHR) 34 105-284 5 WASHER (3/16") 35 106-640 2 SCREW (M6-1.00 X 20MM,BUT SOC)