157 POWERSHIFT MANIFOLD HYDRAULICS RT90M 1. 157-245 1 MANIFOLD (1-SPL) REF NO. PART NUMBER QTY DESCRIPTION REMARKS SEE FOOTNOTE 1 2. 106-385 2 FLG LOCKNUT (M6-1.00) 4. 154-316 2 RUN TEE (04S-04O-04O) 3. 154-743 1 HOSE (04OFX90-23"-3000) 6. 154-220 2 CONNECTOR (04O-06S) 5. 157-909 1 HOSE (060FX-28"-3000) 7. 515-174 1 HOSE (04OFX90-74"-3000) 8. 515-712 1 HOSE (04OFX90L-68"-3000) 9. 117-611 2 ABRASION SLEEVE (1.00" X 22") 10. 154-226 1 CONNECTOR (04O-06S90) 12. 106-566 2 SCREW (M6-1.00 X 70mm) 11. 306-885 2 MOUNT PLATE SEE FOOTNOTE 2 13. 117-387 1 ABRASION SLEEVE (1.00" X 42") 14. 153-564 - TANDEM HYDRAULIC PUMP 150-2680 AUXILIARY PUMP 15. 154-344 1 UN RUN TEE (06OFX-06O-06O) 16.
154-411 1 CONNECTOR (04S-06O) 17. 154-296 1 CAP (04OF) 18. 153-917 - TEE (08N-06O-06O) 19. 157-331 - UN RUN TEE (06OFX-06O-08O) NOT SHOWN: FOOTNOTES: 1. EARLY PRODUCTION MANIFOLDS HAVE A CAVITY PLUG WHERE THE RELIEF VALVE WAS LOCATED. 2. WITH "REAR STEER" OPTION TWO MOUNT PLATES (306-885) ARE REQUIRED, ONE ON EITHER SIDE OF FRAME. WITH "NO REAR STEER" ONLY ONE MOUNT PLATE (306-885) IS REQUIRED ON OUTSIDE OF FRAME. NOTE: REFER TO O-RING CHART (800-301) IN BACK OF THE BOOK FOR REPLACEMENT OF O-RINGS. 03 ID0139935