Komatsu — CHECK BEFORE STARTING ENGINE

. OPERATION OPERATION ADJUSTMENT BEFORE OPERATION ADJUSTING OPERATOR'S SEAT WARNING (A) Fore-and-aft adjustment Move lever (1) up, move the seat to the desired position, then release the lever. Fore-and-aft adjustment:180 mm (7.1 in) [10 mm (0.4 in) x 18 stages] NOTICE 3 - 79 Park the ma chine in a safe place and stop the engine whe n carrying out adjustment of the operator' Adjust the s eat before starting opera tions or when changi ng operators. Adjust the p osition of the operator's s eat so that you can de press the brak e pedal f ully with your back against the seat backrest. (B) Adjusting seat angle r (2) up to increase th tilt to the rear.

ver (2) down to increa e load on the rear of the seat. se the load on the front of the nt tilt, rear tilt: 4 stages each) Pull rear leve The seat will Push front le seat. The se at will tilt to the front. Adjustment r ange: 13 degrees (Fro nt tilt, rear tilt: 4 sta ges each (C) Setting se at for operator's weig ht Sit on the sea t and adjust the stren gth of the suspensi valve (3). Adjustment r ange (Target): 50 kg ( 110 lb) to 120 kg (2 Push: Suspe nsion is strengthened. Pull: Suspen sion is weakened.

(D) Adjusting backrest angle Move lever (4 ) up and move the ba ckrest to the front o When doing t his, keep your back p ressed against the seat back If your back i s not against the seat back, the seat bac k may spring back s Adjustment r ange: 66° to the front ( 72° to rear (3° x If the seat back is reclined too far, the he adrest may hit the rea r glass, so mov e it to a position where it do es not contact the g lass.