. OPERATION DETERMINING AND MAINTAINING TRAVEL ROAD 3 - 114 DETERMINING AND MAI Determining and traveling the road in the jobsite is an extremely important factor both for reasons of safety and for reducing the cycle time.To ensure safet DETERMINING TRAVEL ROAD oad to one-way travel. As far as possible, restrict the travel r If it is impossible to keep to one-way tr affic, make the road with ample width to enable t rucks traveli ng in opposite directions to pass each other. If it is various points along the road. impossible to provide a sufficient road width, provide passing places at aded truck passes on the side closest to the hill face. along the road, set up mirrors.
Always design the road so that the lo aded truck passes on the side closest to the hill If there are curves with poor visibility In places where the road should is we ak or likely to collapse, set up a sign at a point at l east 1.5 m ( 4 ft 11 in) from the road shoulder to warn of the dang er. ectors to enable the road to be traveled at night. ithin 10% (approx. 6°) as far as possible, and emergency escape points n case of any brake failure. It is important to set up lighting or refl ectors to enable the road to be traveled at night. The grade of slope should be kept w should be set up on downhill slopes i Increase the number of places where t he road continues in a straight line.
If there are c urves in hig h-speed travel areas, make the radius of the curve a s large as possible. Small S curves are particularly dange rous, so avoid such curves. The radius of the curve must be a minimum of 12 to 15 m (39 ft 4 in to 49 ft 3 in). possible. is in straight areas. higher on the outside of curves. he road shoulder on the outside of curves. Make the radius of curves as large as Make the road wider at curves than it Make the surface of the road slightly Be particularly careful to strengthen t Design the travel road as far as possib le so that it does not cross any other travel road.
In particula r, when roads cross at an angle on slopes, there is danger that a difference in height will be created in the road, and this will n traveling at high speed. l road for the trucks. d, and this will make the machine sway strongly whe Cut the slope face to provide a specia MAINTAINING TRAVEL ROAD Carry out the necessary action accordin g to the conditions to insure that the road can always be trav eled in safety. Remove any unevenness in the travel surface, sloping to the left or right, or drooping o f the road s houlder. Make the road of ample strength and remov e such obstacles as rocks and tree stumps.
Maintain the road from time to time w Spray the road with water at suitable intervals to prevent dust from rising and reducin g the visibili