Komatsu — OTHER TROUBLE

. OPERATION TROUBLESHOOTING Problem Remedy Wheel on one side tends to slip slack adjuster and brake) Excessive difference in wear between left and right tires Excessive difference in division of load between left and right wheels (unbalanced load) Excessive deformation of disc Bleed air from brakes (left, right). See WHEN REQUIRED. ( Replace tires) Make load uniform ( Disassemble and adjust brake) IF ACCELERATOR PEDAL HAS FAILED The accelerator pedal is equipped with a potentiometer that detects the amount that the accelerator pedal is depressed. In addition, there is a switch that judges if the accelerator pedal is being depressed or if it has been released.

If it is impossible to detect correctly the amount that the accelerator pedal is depressed because of breakage of the accelerator pedal or defective wiring, the engine controller controls the engine in accordance with the signal from this judgment switch. When the accelerator pedal is being depressed, the engine speed is set to 1500 rpm; when the accelerator pedal is released, the engine speed is set to low idling. The speed differs according to the load. Operate the accelerator pedal to move the machine to a safe place, then check the failure code and contact your Komatsu distributor.

When operating the accelerator pedal, release the pedal to turn it to the OFF position (low idling) or depress it fully to set to 1500 rpm. If the accelerator pedal is depressed half way, it may be impossible to judge if the accelerator pedal is being operated. REMARK If the engine controller cannot correctly receive the signal for the amount that the accelerator pedal is depressed, the central warning lamp will flash, the alarm buzzer will sound, and action code "E03" will be displayed. 3 - 137 Main causes