Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE CLEAN INSIDE OF COOLING SYSTEM WARNING *1: When using Komatsu Supercoolant (AF-NAC), there is no need to use a corrosion resistor. When no corrosion resistor is used, use the special cover (600-411-9000). Please consult your Komatsu distributor about the method of installing. When using corrosion resistor, use Komatsu genuine corrosion resistor. If you use another corrosion resistor, it may cause serious problems such as corrosion of the engine and parts of the cooling system that use light metals such as aluminum. The coolant has the important function of preventing corrosion as well as preventing freezing.

Even in the areas where freezing is not an issue, the use of antifreeze coolant is essential. Komatsu machines are supplied with Komatsu Supercoolant (AF-NAC). Komatsu Supercoolant (AF-NAC) has excellent anticorrosion, antifreeze and cooling properties and can be used continuously for 2 years or 4000 hours. As a basic rule, we do not recommend the use of any coolant other than Komatsu genuine supercoolant (AF-NAC). If you use another coolant, it may cause serious problems such as corrosion of the engine and parts of the cooling system that use light metals such as aluminum.

To maintain the anticorrosion properties of Supercoolant (AF-NAC), always keep the density of Supercoolant between 30% and 68%. When deciding the ratio of antifreeze to water, check the lowest temperature in the past, and decide from the mixing table given below. It is actually better to estimate and temperature about 10 ° C (18 ° F) lower when deciding the mixing ratio. The mixing ratio depends on the ambient temperature, but it should always be a minimum of 30% by volume (antifreeze/total amount of coolant x 100). Even in areas where it is not necessary to prevent freezing, use Supercoolant (AF-NAC) at a mixing ratio of at least 30% to prevent corrosion of the cooling system.

The freezing temperature of undiluted antifreeze is -15 ° C (5 ° F). Do not store undiluted antifreeze at a temperature of below -15 ° C (5 ° F). 4 - 26 Immediat ely after the engine is stop ped, the coolant is at high t emperatu re and th e radiator is under high i nternal p ressure. If the rad iator cap is r emoved in thi s condition and th e water i s drained , it may c ause burns. To prevent this, wa it for the temperatu re to go dow n, then turn th e cap slowly to rel ease the internal p ressure. Start the e ngine and fl ush the system .

When standing u p or leavi ng the op erator's se at, se t the gear s hift leve r to the N position and set th e parking br ake switch to t he PARKING positi on.

For detail s of starting the engine, s ee "OPERATIONS, CHECKS BEFORE STARTIN G (PAGE 3-83)" and "STARTING ENGINE (PAGE 3- 84)" in the O PERATION sec tion of the Operati on and M aintenanc e Manual When the undercover is removed, th ere is danger of to uching th Never go to the front of the machine when the engine is running Stop the m achine on l evel ground when cleaning or changin g the co Clean the i nside of the cooling syst em, change the coolant accordin g to the table below Inter Antifreeze coolant val for cleaning inside of cooling system and changing antifreeze coolant Precautions for use Komatsu supercoolant (AF-NAC) Every two years or every 4000 hours whichever comes first 1*