Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE and then remove it. ° When deciding the proportion of antifreeze and water, see "Mixing rate of water and antifreeze". 4 - 28 4. Loosen radiator cap ( 3) a little to release the resid ual pressu 5. Open drain valve (4) at the bottom of the radiat or and dra valve (5) of the oil co oler and drain the coolant. 6. After draining the coo with city water. lant, close drain valves (4) and (5), and 7. When the radiator is f idling. ull of water, start the engine and run at lo After that, raise the c oolant temperature to a t least 90°C (19 F) (guideline: the ind icator of the engine coolant temperatu then run for 10 minutes.

n drain valves (4) and (5), and drain t the water, close them. emperatu gauge is horizontal), then run for 10 minute 8. Stop the engine, ope n drain valves (4) and water. After draining the water, close them. 9. Replace the corrosio n resistor, then turn valve (2) to open it 10. For replacing co CORROSION RESIS Add the water and a port until it overflows. rrosion resistor, see "REPLAC TOR CARTRIDGE (PAGE 4-61)". ntifreeze mixture through the water fill 11. To remove the air co ntained in the coolant, run th e engine at low idling for 5 minutes, th cap OFF.) further 5 minutes. (W hen doing this, leave t he co olant filler 12. Stop the engine.

Ab out 3 minutes later, supply th e coolant up to the coolant filler, then 13. Drain the coolant fro m inside of reservoir t ank ( 6), flush t he int inside of the reservoir tank, then fill with the coolant to a po between the FULL and LOW marks. inside of the reservoi r tank, then fill with the coola nt to a po