. MAINTENANCE SERVICE PROCEDURE BLEED AIR FROM FRONT BRAKE WARNING 4 - 32 Stop the machine on level ground and put blocks under the wheels before To make it easier to bleed the a ir, warm the oil up to a temperature of at least 40°C (104° F) before bleeding the air. Bleed the air from the front bra kes in the same way on both the lef t and right sides. 1. Start the engine, check that the oil in the transmission case is the specified level, and check if the retarder oi pressure caution lamp is out. 2. Remove the cap installed to bleeder screw (1) of the slack adjuster, then insert a vinyl hose. Prepare a container with oil in it and insert the other end of the hose approx.
50 mm (2.0 in) below the surface of the oil. (Use any commercially available vinyl hose.) 3. Depress the brake pedal and loosen bleeder screw (1) approx. 3/4 turns. Keep the pedal depressed until no more bubbles come out from the vinyl hose. 4. Pull the retarder control lever and loosen bleeder screw (1) approx. 3/4 turns. Keep the retarder control lever depressed until no more bubbles come out from the vinyl hose. 5. After bleeding the air, tighten bleeder screw (1) securely and fit the cap. 6. The procedure for bleeder screw (2) of the front brake is the same as for the slack adjuster (with Step 4 excluded).
NOTICE The brake oil pressure caution lamp may light up during the air bleed operation. Ifthis happens, tighten the bleeder screwand depress the brake pedal 8 - 10 times to charge the accumulator with oil pressure. Use sight gauge (H) to check if there is oil remaining in the brake oil tank. If there is no oil, stop the engine. (When the engine is stopped, the oil level will rise and oil will be automatically supplied to the brake oil tank.) 7. After finishing air bleeding, stop the engine (for 2 to 3 minutes), and adjust the oil level so that it reaches the specified level. For details, see "CHECK OIL LEVEL IN TRANSMISSION CASE, ADD OIL (PAGE 3-74)". 1.
Start the engine, check tha t the oil in the transmission case is the specified level, an d check if the retarder oi