Komatsu — EVERY 250 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE CHECK AIR CONDITIONER COMPRESSOR BELT TENSION, ADJUST CHECKING initial elongation, so adjust the belt 4 - 47 Press compressor pulley (1) and drive pulley (2 ) with a fi nger pressur e of approx. 58.8 N {6 kg}) If deflection (A) is 10 mm (0.4 in), the bel t tension ADJUSTING 1. Loosen bolt (1). 2. Press the belt at a compressor pulley approx. 58.8 N {6 deflection is appro 3. Tighten bolt (1) a position. 4. Check each pulley of the V-belt. In par touching the botto 5. If the V-belt is so more or if it has an 6. If the V-belt has b operating for 2 to point midway between the air conditioner 1. 2. 3. 4. 5. 6. 1. 2.

compressor pulley and drive pulley ger pressur e of approx. 58.8 N {6 kg}) and turn nut that the deflection is appro x. 10 mm (0.4 in). 3. Tighten bolt (1) a position. 4. Check each pulley for damage, wear of the V-g roove, and w ear of the V-belt. In par ticular, be sure to c heck tha t the V-belt is not touching the botto m of the V-groove. 5. If the V-belt is so lengthened that it more or if it has an y cuts or cracks, r eplace it. 6. If the V-belt has b operating for 2 to again after