. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE Rear CLEAN, CHECK RADIATOR FINS AND AFTER COOLER FINS WARNING around dust and debris, there is danger of injury. Always wear protective equipment such as fins can be 4 - 56 If comp ressed air protect ive glasses and m If the r adiator fin s or a ftercooler fins become clogged o r bent , this will ca use overheating of the engine. ed, clean the fins. Inspec t the fins. If an y fins are clogg ed, clean the fins. If any pin is bent , please ask your Ko matsu distributor t o carr y out repairs . Cle aning can be carried out by usi ng jets of air, steam , or w ater, but be careful not t o let the nozzle contact the fin.
Wh en using c ompressed air or ste am, keep the nozz le at a right ang le to the ra diato r and after coo ler. Exa mine the r ubbe r hose, and if a ny cracks or brittle place s are foun clam d, replace hose. In additio oose hose NOTICE If stea damag ed, so keep a goo d distance in bet ween when cleaning Use the following values as a benchmark Jet p ressure: L ower t han 9.8 MPa (100 Nozz le diameter : Less than 2 mm (0.0 Dist ance betwe en nozzle and fin (A): More than 100 mm (4