Komatsu — CONTENT OF DISPLAY (CONTROLLER, EXTERNAL DISPLAY LAMPS)

. ATTACHMENTS, OPTIONS HANDLING PAYLOAD METER HM DISPLAY DURING NORMAL OPERATIONS *1: If the machine is stopped again before traveling 5 m (16 ft 5 in), the machine display portion/external display lamps will both return to the loading stopped display. After traveling more than 5 m (16 ft 5 in), the machine will recognize the payload. *2: When the dump body is raised, the payload for that cycle is confirmed. If the dump body is lowered fully again and more than 50% of the specified standard payload is remaining, it will be taken as mistaken operation. It will not be recognized as the completion of dumping. *3:

The display for the total payload is given in units of 100 t (rounded to the nearest 100). For the method of clearing the total payload (resetting of the measurement to 0), see "FORCED DISPLAY OF TOTAL PAYLOAD AND OVERALL NUMBER OF CYCLES (PAGE 6-20)". Even if the power for the payload meter is turned off when the machine is traveling empty, the condition of the machine during loading or when traveling loaded is retained, so when operations are started again, the payload meter starts from the same condition of the machine. Do not turn off the power during dumping. The correct data will not be written.

NOTICE There are cases where there is a difference between the condition of the machine recognized by the payload meter and the actual condition of the dump truck, an accurate measurement cannot be made. In the following cases (1) - (3), please consult your Komatsu distributor. (1) When a new controller has been installed (2) When the controller has been replaced (3) When the internal battery has been replaced If the above "Normal operation display" is not given, stop the machine unloaded, and raise and lower the dump body. Do not turn the power off during dumping. If the power is turned off when the dump body is raised, it may be impossible to record the cycle data accurately.

6 - 11 Condition of machine Gear shift lever position Dump body position Display panel External display lamps When empty Stopped N seated Time display OFF Traveling Except N seated Time display OFF During loading Stopped N seated Payload display Payload display and display of estimate Traveling (*1) Except N seated Travel distance display OFF When loaded Stopped N seated Payload display Payload display Traveling Except N seated Time display OFF When dumping (*2) N seated → unseated Total payload display (*3) [100 tons] OFF When abnormality or warning is generated - - See "ABNORMALITY AND WARNING DISPLAY (ERROR CODE)"