. ATTACHMENTS, OPTIONS HANDLING PAYLOAD METER HM METHOD OF CARRYING OUT CALIBRATION (METHOD OF OPERATION) switch (1) pressed for at least 2 seconds. (The letters CAL flash) 2. Press CAL/CLR switch (1) again. (Letters CAL light up.) 3. Shift the gear shift lever to 2, depress the accelerator pedal 5. Stop the machine slowly. After stopping the machine completely, return the gearshift lever to N . Use the 6 - 19 1. Move the gears hift lever to the N position and keep CA n a straight line. When th e travel spee .6 MPH), the elapsed time is displayed 4. The present pay load measurement value i s displayed 30 second s after carryin g out calibratio Release the foot brake or r etarder brak 6.
If the dump body is empty, the measureme ntvalue for th e payload i s measured a s approx. 0.0 to ns. If more than ±1 tons is displa yed for the payload, carry out calibrati on travel a gain. 7. Press the MOD E switch. The display cha nges to the n ormal operation display NOTICE Carry out the calibr ation on a flat road surface w ith no uneven places. The flatter th e roa d surface is, the more accurate the measurement beco mes. ine. (Distance: Approx. 120 m (393 ft 8 in)) out the calibration accurately. If calibration is not carried out accurately, there will be an error in the payload, so the measurement will not be correct. ever to 2 and depress the accelerator pedal fully.
Do not let the accelerator pedal back. Travel in a straight l ine. (Distance: Approx. 120 m (393 ft 8 in)) Be careful to carry out the calibration accuratel y. If calibratio measurement of the payload, so the measureme nt will not be c Shift the gear shift l ever to 2 and depress the acc elerator pedal fully. Do n ot let the a ccelerator pedal back The calibration data are saved to the internal RAM . After calibrat ion is being carried ou t, eve n if the power is t urned off, the data are retained. If it is desired to sto p the calibration during the ca libration opera tion, press t he MODE switc h while the letter s CAL are flashing in Step 1.
The displ ay will change from CAL to th e normal disp lay. If an erroroccurs on the machine, depending on th e error,it may be impossib le to carry out c alibration. For d etails, see Section "ABNORMALITY AN D WARNING DISPLAY (ERRO R CODE) (PA GE 6-30)"