. ATTACHMENTS, OPTIONS HANDLING PAYLOAD METER HM operation (PAGE 6-28)". 6 - 31 *1: Please consult your Koma *2: If this problem occurs, it is impossible to carry out calibratio n travel. *3: (1) If more than 2600 cycles a re saved in memory (space for 3 00 cycle s remaining), "L:FUL" flash (2) If more cycles are recorde d and the total exceeds 2900 cycle s, numbers 2901, 29 02, etc. are sa ved in memory, but the oldest cycle data a (3) If this error code flashes, d ownload to the PC, then delete a ll data. For details, s ee Section "(e ) Data all clear *4: Engine ON/OFF data FUL L saved in memory (space for 10 times remaining), "E:FUL" flashes.
(1) If more than 105 times are saved in memory (space for 10 t imes re maining), "E: (2) If more times of engine ON /OFF are recorded and the total ex ceeds 1 15 times, nu mbers 116, 117 , etc. are s aved in memory, but the oldest engine ON/OFF data are deleted in turn. (3) If this error code flashes, d ownload to the PC, then delete a ll data. For details, s ee Section "(e ) Data all clear operation (PAGE 6-28)". *5: When equalizer bar conta cts stopper (1) If the equalizer bar is in co ntact with the stopper, an accurate measurement cann ot be obtained. If the machine is stopped empty at the lo ading point, contact between the equalize r bar and sto pper is detecte d.
(2) Drive the machine forward a little at a time until error code "F -FL" dis appears from the display. S et the gearshift lever at D. After stopping the machine, return the gearshift lever to N. *6: Articulation angle too large If t he dumping mode is selecte d when measuring, the measured value i s saved imme diately before the dump body is r aised. If the articulation an gle is too large when the measurement i s made, the a ccuracy will be poor. "F-AC" is displayed when the d umping mode has been selected and the articulation h as been turned more tha n half (approx.
22.5°) when the mac hine is stopped while loaded If " F-AC" is displayed when d umping, set the machine facing st raight s o tha t the err or code is not d isplayed. WHEN ERROR CODE F- 09 IS DISPLAYED ernal battery to prevent the recorded data from being deleted when the key in the OFF position. Th e payload meter has an int starting switch is turned to the If t he battery voltage drops, er ror message [F-09] is displayed. If [F-09 ] is displayed, it is necessar y to replac e the internal battery. Please cons ult your Komatsu distributor.