Komatsu — SWITCHES

. OPERATION EXPLANATION OF COMPONENTS STARTING SWITCH This switch (1) is used to start or stop the engine. the flow of 3 - 31 OFF position : The key can be rem oved from the starting switch, electricity to the electr ical system is cut, and the engi ON position : In this position, electr circuits. ic current flows in the charging and lamp Keep the starting switc h key at the ON position while the engine is running. When turning the start ing switch ON or OFF, if the st arting switch is held at a position between ON and OFF, the co ntroller may detect this as a proble m. If this happens, return the st arting switch to the OFF position, th en operate it as usual to the O N position.

In cold weather, if the key is turned ON, engine prehe ating starts automatically and the pr eheating pilot lamp lights up. When preheating is completed, the preheating p ilot lamp goes out. START position : This is the position to s tart the engine. Hold the key at t his position while cranking. Release the key immediately after the engine has been s tarted. The key will return to th e ON position when released. LAMP SWITCH This switch (2) lights u p the head lamps, side clearan ce lamps, tail lamps, machine monit or lighting, and rear lamps. rance lamps, tail lamps, rear lamps, and monitor lighting light up. d lamps light up in addition to the side Position (a): OFF Position (b):

Side clea machine Position (c): The hea clearance monitor li lamps, tail lamps, rear lamps, and machine ghting. The lamp switch can b e turned to switch the lighting r egardless of the position of the turn signal lever. TURN SIGNAL LEVER s the turn signal lamp. e lever forward lever back This lever (2) operate (a)Right turn: Push th (b)Left turn: Push the When the lever is oper ated, the turn signal pilot lamp also flashes. The lever is automati cally returned when the steer ing wheel is and. turned back. If the lev er does not return, move it by h