. OPERATION OPERATION (G) Adjusting headrest angle Rotate the headrest to the front or rear. 3 - 99 (E) Seat height adju stment Move lever (2) up/d own, then move the seat u p or down as desire d. Since lever (2) is also used for adjustin g seat angle, set the seat t o the desired height while adjusting th e angle. Adjustment range: (F) Adjusting headr est height Move the headrest up and down to the desire Adjustment range: 50 mm (2.0 in) (H) Adujusting armr Adjust angle of arm rest by rotating knob (5) (l eft side only) Adjustment range: 30 degrees (forward tilt: 25 degrees, ba ckward Also, when armrest is turned, it will spring up.
(Both left a nd right LUMBAR SUPPORT T YPE SEAT NOTICE When pulling up le vers (2) and (3), be careful no t to pull up th e switch box at the front by mistak e. There is danger t hat the switch box may be damaged. When the left armr est is at the raised position, do not push d own on t he tip of the armrest with your hand to suppor t your weight. There is da nger that the armrest mount may be damag ed. Adjustments (E), (J ), and (K) use the air comp ressor built in to the s eat, so turn the engine starting switch to th e ON position when carry ing out the adjustment. (A) Fore-and-aft adj ustment Pull lever (1) up, se t the seat to the desired p osition, then release the lever. ent:
180 mm (7.1 in) (10 mm (0.4 in) x 18 stages) Amount of adjustm (10 mm (0.4 in) x 18 st (B) Adjusting seat a ngle Move lever (2) up an d apply your weight to the r ear of the se at. The seat will tilt to the re ar. nd apply your weight to the front of the seat. he front. ent: 24 degrees (front and rear tilt: 3 stages Move lever (3) up a The seat will tilt to t Amount of adjustm each) (C) Adjusting heigh t of seat d (3) up and move the seat up or down to the Move levers (2) an desired position. These levers are al so used for adjusting the s eat angle, so adjust the seat angle to se t the seat to the desired h eight. Amount of adjustm ent: 65 mm (2.6 in)